ReMote 360 Installation Instructions
YouTube Instructions:
Step-by-Step Instructions
1: Mount lever to your handlebars.
The ReMote 360 can be mounted above or below the bar, on the left or right side. Choose the position that works best for you.
2: Rotate the barrel adjuster clockwise to ensure it is all the way in.
3: Route cable housing from your dropper to the barrel adjuster.
Guide the cable from the dropper, through the housing, and through the base of the ReMote 360
4: While holding the cable taught, measure and cut the cable to 35mm past the exit face.
Do not add a cable crimp.
5: Slide the lever over the cable end, being careful not to push the cable back into the housing.
With the lever pressed up against the base, tighten the set screw on the lever to pinch the cable to 1nm.
6: Turn the barrel adjuster counterclockwise to remove any play
7: Fine tune the positioning of the lever if needed.
Tighten the clamp to 1-2Nm.